1. Turn off the collar by pressing and holding the power button for 3 seconds. Confirm it is turned off by checking that the LED indicator light is not flashing.

2. Turn on the collar by pressing and holding the power button for 1 second. The blue LED indicator light on the collar flashes alternately to enter the code checking state.

3. Press the “Buzzer” and “Vibration” buttons on the remote at the same time to send the code checking instruction to the collar. 

4. Test the system to confirm it is paired.

Note: If you would like to pair two collars to one remote controller, please make sure the dog channel on the remote controller is switched to 2. Repeat the steps above to set up your second dog training collar.

If you have any questions, please contact us for further assistance.