There are two methods of mounting the keypad at the selected location:

Use Adhesive Strips:

1. Stick the adhesive strips on the keypad, and then peel off the removable film. 

2. Stick the keypad onto the wall.

Use Mounting Screws:

1. Slide the mounting bracket off.

2. Place the mounting plate against the wall, then match both UP and Down as indicated on the back of the mounting bracket.  Push a pencil tip through the holes on the mounting bracket to mark the location for mounting the keypad.

3. Drill holes with a drill bit (15/64” / 6 mm) at each marking.

4. Insert anchors into the holes, and then install the mounting bracket onto the wall with the provided screws.  Please note it is not necessary to install anchors on wooden walls.

5. Slide the keypad down until it snaps perfectly onto the mounting bracket.