What should I do if the MACH V1 series triggers an insufficient water error when there is water in the clean water tank?
Please add cold tap water to the clean water tank and do not exceed the MAX mark before using the MACH V1 series. If the MACH V1 series triggers an insufficient water error when there is water in the clean water tank, this error could be caused by the rubber cover on the clean water tank or the clean water tank is not installed properly.
Please try the following troubleshooting steps to verify if the issue can be resolved:
1. Verify the rubber cover is installed properly by opening the rubber cover and then fully pressing it down. Please note that the surface of the clean water tank should be smooth if the rubber cover is completely sealed.
2. Make sure the clean water tank is installed properly. Please verify the gap between the bottom of the clean water tank is evenly aligned with the main body of the vacuum cleaner.
3. Confirm the nozzle is positioned correctly, and then power on the MACH V1 series to observe whether the vacuum cleaner is dispensing water from the clean water tank.
If you have any further questions, please contact us for assistance.
What should I do if the MACH V1 series triggers an insufficient water error when there is water in the clean water tank?
Download
Applicable for those products :
Resolved
Unresolved
Copied
0 Results
Manuals & Downloads
【T8010】【HomeBase 2】EU Declaration
Download
T8113S_EU Declaration of Conformity
Download
eufyCam_2C_Pro_Set_Manual_us
Download
RoboVac 30C_Manual_EN
Download
video_Doorbell_2K_(Wired)_Manual_us
Download
Motion_Sensor_manual_us
Download
RoboVac 35C/25C_Manual_EN
Download
720p_Video_Baby_Monitor_manual_us
Download
HomeVac S11 Go/Reach/Infinity_EN+ES_Manual
Download
eufyCam_2_Pro_Set_Manual_us
Download
Support Videos
