What can I do if my RoboVac dispenses too much water while mopping the floor? (For RoboVac G10/G20/G30 Hybrid Series)
If you noticed the RoboVac is dispensing too much water while mopping the floor, please try the following troubleshooting steps.
- Remove the water tank from the RoboVac and inspect it closely to make sure it is not damaged.
- Check to make sure there are no ruptures between the water tank and the RoboVac that could cause water to leak.
- Verify filters are installed correctly.
- Properly install the water tank and the dust collector.
- Verify the mopping module is installed correctly.
If your RoboVac is still dispensing too much water while mopping the floor, please contact us for assistance
20 undefined
How to order a water tank for G10/G30 Hybrid?
How to order filter elements for water tank (G10/30 Hybrid)?
What if my RoboVac has a clicking noise in the side brush?
How to mop with G10/G20/G30 Hybrid?
What to do if the RoboVac top glass is cracked?
How to order a bumper for my RoboVac?
What should I do if RoboVac's movements or travel path are abnormal?
How to use the Boundary Strips to block off RoboVac?
How to order washable mopping cloth for my RoboVac?
RoboVac G30 Series/G40 Series EU DOC (T2250/T2251/T2252/T2253/T2254/T2255/2256)
RoboVac G10 Hybrid_Manual_ES
RoboVac G10 Hybrid_Manual_FR
RoboVac G10 Hybrid_Quick Start Guide_AR
RoboVac G10 Hybrid_Quick Start Guide_EU
RoboVac G10 Hybrid_Manual_CN
View More
How to Replace Bumper of RoboVacs
Troubleshooting if RoboVac Cannot Power On
How to Use the Mop Function of G10/G20/G30 Hybrid
RoboVac Battery Replacement and Installation Video (for 11S series)
How to Replace the Swivel Wheel for the Max and G series RoboVacs
How to Clean Swivel Wheel
View More
