Please follow the steps listed below to replace the hard drive in the NVR central hub:
-
Prepare a new compatible hard drive and a Phillips head screwdriver.
-
Power off the NVR central hub and disconnect it from the network.
-
Verify the position of the hard drive mount in the NVR central hub, as illustrated in the image below.
-
Before removing the existing hard drive, ensure that all important data is backed up.
-
Use a Phillips head screwdriver to remove the 5 screws securing the top cover.
-
After removing the screws, carefully lift the lid and gently disconnect the SATA cable connected to the hard drive.
-
Flip the NVR central hub upside down, and then hold the hard drive while unscrewing it to prevent it from failing down.
-
Choose a slot according to your hard drive. Take out the silicone plugs from the screw holes prior to installation.
-
Hold the hard drive in place while you insert the screws into the mounting holes, then tighten the screws.
-
Insert the silicon plugs.
-
Position the NVR central hub upright and connect the SATA cable.
-
Install the top cover with the 5 screws.
-
Reconnect all cables to the NVR central hub.
-
Power on the NVR central hub.
If you have any other questions about the PoE NVR Security System, please don't hesitate to contact us for further assistance.
